What Does A Roof Jack Look Like

Also before you start installing your flashing you need to look to see if the wall in question has a corner on the roof face as in the image below.

What does a roof jack look like.

You can usually feel sheathing nails which are driven into rafters through the underlayment attach a jack by driving two 16d nails never roofing nails into a rafter. If it does follow our first installation procedure. A roof jack will not do you any good without planks of lumber to span them. Standard 2 by 10 inch lumber with fit into the channel on most roof jacks and should be available at any lumber yard.

Roof jacks provide a stable surface to work increasing safety and making it easier to apply roofing. Avoid using short pieces as the risk of a length of lumber tipping upward if you should happen to step onto the end of it is greatly increased. Cut roof shingles to fit around the roof jack and insert them under the existing shingles. What causes a sagging roof line.

Ideally locate a rafter below the sheathing. Roof lines should be arrow straight. Nail the new shingles down with roofing nails so the nails are covered by the shingle above. Use a hammer to bend the top edge of the soft lead roof jack down into the vent pipe.